News

Correct Use Of Mold Release Agent

Update:2022-09-16 00:00
Summary:

Correct use of Mold Release Agent :

1. First, use a clean, dust-free cloth to fill the mold release agent, and then apply it evenly and orderly on the surface of the mold. Be careful not to work on the mold surface that has just been wiped with the mold release agent. You need to wait until the mold release agent is completely cured before making the product. ;

2. Generally, 2-3 layers of primer need to be applied, and an interval of 8-10 minutes is required between each primer to wait for the release agent to cure. It takes 15-20 minutes for the last layer to fully cure the release agent before production. (Note: the bottom film must be dry and non-stick; new molds and molds that have just been cleaned need to be coated with release agent 4-5 times);

3. Only when the mold surface and fine parts are fully and evenly applied to the mold release agent, a better mold release effect can be guaranteed;

4. When there is difficulty in demoulding, you can choose to apply the release agent to the entire mold again, or only apply the position where the demoulding is difficult.