Industry News

Correct Use Of Mold Release Agent

Update:2022-12-09 00:00
Summary:

Correct use of Mold Release Agent :

1. Dip the release agent with a clean dust-free cloth first, and then apply it evenly and orderly on the surface of the mold. Be careful not to work on the surface of the mold that has just been wiped with the release agent. It is necessary to wait for the release agent to completely cure before making the product. ;

2. Generally, it is necessary to apply 2-3 layers of bottom film, and it is necessary to wait for the release agent to cure at an interval of 8-10 minutes between each layer of bottom film. It takes 15-20 minutes for the last layer to be produced after the release agent is completely cured. (Note: The bottom film must be dry and non-stick; new molds and newly cleaned molds need to be coated with release agent 4-5 times);

3. Only when the mold surface and fine parts are fully and evenly applied to the mold release agent, can a better mold release effect be guaranteed;

4. When it is difficult to release the mold, you can choose to apply the release agent again on the whole mold, or only apply the release agent to the position where the release is difficult.